In version 2012 this setup worked correctly except that version didn't have the option to delete old backups automatically, which was not a big deal as it did warn me about disk space running low on my D: drive and I had then manually deleted an old backup and pressed continue. After my last backup error I have exported the Acronis System Report and I have not detected any errors in the report. Now with version 2017 the backup either reports that the destination path is not valid or at the end of the backup it reports a write error without further explanation.
I have a backup job set for every day at 09:30 to perform a full backup of my system drive on both drives I have the same path "D:\My backups\INTEL SSDSC2BW480A4" to which the backup job has it's destination set to on both locations I have a HP Advanced docking station with extra HDD built in which is mounted on drive letter D: HP Elitebook notebook computer which I use at home and at my office Now for a little more detail about my setup: No I have not defined a new backup job yet as to why should I this has to work! Yes I ran already all system checks and seen through the sytem report for errors and no errors are reported nor any change in behavior. Now after upgrading to version 2017 no backup has been finished yet. Hello to all, I have been using Acronis True Image version 20 and now I have 2017, which by the way seems to be the only one working correctly for my setup *the 2012 version*.